Rom tuning software

You can add the factory cruise control steering wheel, and associated switches. Most vehicles have the wiring installed and are a simple plug and play. Please verify prior to ordering any parts. Once installed, flash a rom that has cruise from the factory. If you are not sure what rom to flash please contact your local UpRev dealer or contact support uprev.

The Titan only allows for 3 maps. When the ECU is reflashed it is given new targets to learn to. Over time as the ECU does learn the tune will get better as your vehicle learns to run closer to the new values. The initial flash should take about 1 min. Consecutive flashes thereafter will only take a matter of seconds. Yes, UpRev Tuning Suite is for end users who want to do their own tuning.

We support our product on Windows 8 and above only. Earlier versions of Windows are no longer supported. Using the Cruise Control Buttons RomRaider is open source software licensed under the GPL , developed by enthusiasts, which allows for tuning and data logging of Subaru ECUs without having to invest in expensive hardware and software. Best of all, RomRaider is free. A special cable, manufactured by Tactrix, is used to connect your laptop to the OBD-II port in your car which is located below your steering wheel.

As long as you keep a back-up copy of your original image, you can revert back to it at any time. In addition to tuning, RomRaider also allows you to data log your Subaru to monitor the results and safety of your tune. Q Which Subaru models are supported by RomRaider? There is currently limited support for other ECUs. The OpenPort 2. This new version of the cable supersedes all prior versions and is the only version currently being sold by Tactrix.

Older versions of the cable, such as the OpenPort 1. So even if the car has enough voltage to start, it may not be enough voltage for the reflash portion of the diagnostic cable. Therefore I highly recommend that you have a battery charger connected whilst doing reflashes, or have the car run for at least 1 hours driving to get the battery voltage level really high.

If you are running the car between flashes on a dyno for instance, then this should be sufficient. Try and keep the battery level above Troubleshooting Reflash: Does your cable datalog ok? If the voltage regulator is bad in the cable and not sending 12volts to flash connector, check this some people have added a switched 12volts for flashing and works fine. Please note that the Pro license purchase is not automated. In other words, you will need to wait for the developer to get you the registration string after purchase.

So, if you need a Pro license you may want to purchase this well before you need to begin tuning. Getting Started:. On your Laptop, go to the Crome webpage: www. Download the most recent version of the Crome software. The password is pgmfi.