Youtube how to install carpet on stairs

Insert the carpet tool between the tack strip and the riser. Push the carpeting down over the tack strip by hitting the carpet tool with a rubber hammer all across the back of the step. Staple the carpeting to the riser several inches above the stack strip. Repeat these steps moving up the stairwell until you reach the top of the stairway. Cut the runner at the top step so that there is enough left to turn under the top cap and staple it in place.

Writing fanzine-based articles since , Kasandra Rose writes and edits articles for political and health blogs and TrueBloodNet. By Kasandra Rose. In order to keep the runner in place, you will need to create and install one pad for each stair tread. This step could be skipped if you use enough staples.

If you choose to go this route continue to read on, if not skip to step three. Use this pad as a guide to cut as many as you will need for each stair tread. Using a measuring tape for accuracy, center the pad on the bottom tread and align the long edge with the riser above. Leave a space about the width of one fingertip between the pad and the back of the riser. Next, smooth the pad over the tread and pull tightly over the nose, careful not to over-stretch the pad.

Staple the pad to the underside of the nose, repeating the pattern of one staple at the center line, and two on either side. Trim any excess padding if necessary. Repeat this process until one pad is attached to each tread. Unless you choose a runner with a non-slip backing, you will need to use carpet padding. Ideally, carpet padding should be used under any rug that is at risk of sliding around. Without carpet padding, stair runners are at risk of slipping out of place, which can not only look sloppy, but lead to dangerous slips and falls.

Note that carpet padding is designed specifically to go over either carpeted or hardwood floors, so be sure to choose the right one for your situation. Padding designed for hardwood floors will not work well over carpet! Begin by cutting a strip of double-sided carpet tape, slightly shorter than the width of the carpet runner.

Place this tape along the riser of the first tread, just under the nose. Once the runner is attached to the tape, use your staple gun to drive one staple into the center of the edge of the rug, and another every three inches from the center on either side.

You must be logged in to post a comment. Customer Rating : 4. Categories Carpet Interior Design. Tags install stair treads non slip stair treads pet stair tread pet stair treads. How to install stair treads carpet Carpet treads minimize slipping and increase traction. Great for pets and pet owners! They help extend the life of your high traffic hardwood stairs. Next, you need to use a knee kicker to stretch the seam of the carpet so that it stays close to the step. You need to begin in the middle of the step and work outwards.

This will allow the carpet to stay closer to the curved part of the step and gives it a more fitted look. Then, you want to make that look even more defined. Using your stair tool and the rubber mallet to create a crease along the same line where you stretched the carpet. Use stick the stair tool in the crease and use the rubber mallet to hammer it. This will push the carpet onto the tackles strip better and create a crisp crease that you are looking for.

Looking at the stairs now that you have installed the carpet yourself, you should feel accomplished. And, now that you know how to install carpet on stairs, you can help others to do the same. This finishing touch can make your home look comfortable and it can make it safer as well. Keep in mind that carpets get dirty with time, so you might want to vacuum your stairs , and use a portable carpet cleaning machine.